Jump to content
  • entries
    32
  • comments
    64
  • views
    15,424

Update 2

nebnoswal

403 views

blog-0310816001422440336.jpgThe last couple of months has seen me trying to finish of some the many UFO's. On the list were some LMS 6 wheeled CCT's. These are brass etches made by Etched Pixels, which glue on to a 3D print body, which in turn fits onto a NGS 6 wheels chassis from the stove R.

blogentry-6928-0-25043300-1422439354_thumb.jpg

These were quite simple to build. I opted to solder the sides together and then glue the body. The body's come with or without rainstrip. While the printed strip is a bit thick, added brass wire and shaping was a tad difficult

blogentry-6928-0-64339700-1422439575_thumb.jpg

Roof and end painting occurred today, now they just need decals. That is another story, for another time.

blogentry-6928-0-10790100-1422439865_thumb.jpg



1 Comment


Recommended Comments

Looking good. I superglued my sides but your soldered versions look better.

 

What paint did you use for the body sides?

Share this comment


Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.