Chagford - Video of Train Running
Hello All
I have been wiring the track for DCC, this I though was a simple task, but when I checked my work with a multimeter the rails were shorted. After disconnecting various wire I discovered that one of the pre-cut sleepers was not cut properly. This corrected and the wires reconnected the short has been corrected.
Three of the sections of track are held in position using two screws. This is to allow them to be removed to allow a cross over to be installed later.
Next I ran a locomotive, which I recorder using my camera phone.
I could not get the locomotive to go round the 78mm radius curve, but this is caused because of a problem with the baseboard join, and the track currently has a hump in the track.
Lisa
- 1
6 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now