Vortexwake

Ok thanks for the reply will message them.

Hi folk I have a Bachmann class 57 which I need to increase the sound of the two tone horn and air brake Sound I have read the manual and get terribly confused so I was wondering if one of you knowledgeable Chaps could steer me to the right cv's Thanks in advance Steve

Hi Richard That worked ok I can hear it now thanks for your time. Steve

Hi Richard Thanks for posting I set cv259 to 128 and is still very faint. Steve

Ok thank you Charlie. Steve

Hi folks I have Bachmann class 57 fitted with a Esu lok sound v5 decoder, is a very faint brake squeal when stopping the cv63 is set at 180 I have read the manual and got rather confused wondering someone could point to right cv to bring the level up. Thanks for any advice. Steve

Thanks for replying yes you are correct should have read up. Steve

Hi folks In a effort to get a troublesome Bachmann / lok sound 5 37 from stuttering I enabled the complex Speed curve now I find that the decoder won't reset and switch it off I used the 2mm society cv 29 Calculator. Any suggestions would be most welcome Steve

Hi The thing I don't understand is the fact it was running superbly one minute Then it stopped dead the next. Steve

Hi Richard I checked and they are ok. Steve

Ok thank you I will check. Steve

Hi It was on dc c I have another Bachmann 37 which runs superbly o my layout Thanks for all replies. Steve

Hi Well I cleaned the wheels pick ups and track to death put back on the track it inched forward And stopped so I know the motor is ok I am at a loss now. Steve

Hi Thanks for replying I have checked the pins and they are ok I unscrew ed the bottom chassis and was able get A finger in and turned the fly wheels and they are free I don't know to get at the motor to test With dc Steve

Hi I have a Bachmann class 37 dc c sound lok sound v5 I have had nothing but running problem s with it stuttering etc I did a cv8 reset no joy I switched the chip with a blank and ran it on dc it was ok put the v5 chip back and now it Won't run on dc c or dc there is no humming from the motor have I blown the motor...? I have all the sound and lights so I don't Think it's the decoder. I am using a Gauge Master Prodigy Express 2. Thanks for advice. Steve.