Jump to content

Standard 3MT Tank loco


Recommended Posts

I recently acquired a secondhand one of these; as it needed some fettling (actually re-soldering the yellow wire) to get it running, I'm having difficulty re-fitting the body. Despite following the instructions, either the cab roof rises up or the nearside tank won't align with the running plate when the fixing screw is tightened. I've made sure the wires sit properly within the castings. I notice a couple of 'pips' on the lower edge of the casting above the leading drivers but these seem to correspond with depressions in the front of the body tanks, so wouldn't appear to be a factor.

I'd be grateful for any advice. TIA.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...