RMweb Premium Crepello Posted February 16, 2016 RMweb Premium Share Posted February 16, 2016 I recently acquired a secondhand one of these; as it needed some fettling (actually re-soldering the yellow wire) to get it running, I'm having difficulty re-fitting the body. Despite following the instructions, either the cab roof rises up or the nearside tank won't align with the running plate when the fixing screw is tightened. I've made sure the wires sit properly within the castings. I notice a couple of 'pips' on the lower edge of the casting above the leading drivers but these seem to correspond with depressions in the front of the body tanks, so wouldn't appear to be a factor. I'd be grateful for any advice. TIA. Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.