Guest Lyonesse Posted November 16, 2019 Share Posted November 16, 2019 Can anybody point me to a source of good 1/8 brass (or p/b) plain, top-hat bearings? I've bought a few types, but most of them seem to have a rather generous, sloppy hole. What I want is bearings that can be soldered in place then reamed to give a good, close running fit. Link to post Share on other sites More sharing options...
RMweb Premium 30368 Posted November 16, 2019 RMweb Premium Share Posted November 16, 2019 I use Alan Gibson 1/8 bearings and they would suit your requirement. I always have to ream following soldering. Kind regards, Richard B Link to post Share on other sites More sharing options...
Guest Lyonesse Posted November 16, 2019 Share Posted November 16, 2019 11 minutes ago, 30368 said: I use Alan Gibson 1/8 bearings and they would suit your requirement. I always have to ream following soldering. Kind regards, Richard B Interesting you say that, I've found Alan Gibson's 2mm bearings to be quite sloppy. In fact I generally regard AG products as having fairly generous tolerances. Link to post Share on other sites More sharing options...
billbedford Posted November 17, 2019 Share Posted November 17, 2019 20 hours ago, Lyonesse said: Interesting you say that, I've found Alan Gibson's 2mm bearings to be quite sloppy. In fact I generally regard AG products as having fairly generous tolerances. Check the tolerances of your axles, they are more likely to be undersized than the bearings sloppy. Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now