eldomtom2 Posted March 25, 2020 Share Posted March 25, 2020 This has completely defeated me. No matter what, I cannot get the point to have both tracks attached to other pieces - they just won’t fit. I have used every piece in the packet in every configuration I can think of, and it still doesn’t fit. Link to post Share on other sites More sharing options...
RMweb Gold Jonboy Posted March 25, 2020 RMweb Gold Share Posted March 25, 2020 Link to post Share on other sites More sharing options...
eldomtom2 Posted March 25, 2020 Author Share Posted March 25, 2020 I see how it's supposed to fit together, but it doesn't. Link to post Share on other sites More sharing options...
RMweb Gold PaulRhB Posted March 25, 2020 RMweb Gold Share Posted March 25, 2020 Have you got a photo of the parts laid out almost in place but not attached so we can see if there’s anything obvious? Link to post Share on other sites More sharing options...
wasdavetheroad Posted March 25, 2020 Share Posted March 25, 2020 Easy! - start with point - remove ballast shoulder from inside of small curve and connect to diverging track on point - connect short straight to point with the 'wedge' fitting into the gap in the small curve ballast shoulder - connect large curve to small curve - connect long straight to 'wedge' straight Job done Remember to keep the small curve ballast shoulder Link to post Share on other sites More sharing options...
eldomtom2 Posted March 26, 2020 Author Share Posted March 26, 2020 15 hours ago, wasdavetheroad said: - remove ballast shoulder from inside of small curve and connect to diverging track on point This is the step I was missing, thanks. Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now