Talltim Posted September 8, 2015 Share Posted September 8, 2015 I've got a couple of Cobalt Digital (not the new iP ones) point motors, but I'm actually controlling them with push to make buttons (I was planning to set them up for DCC control but changed my mind) . If I leave them with the default setup with the switch left in Run and power them from the DCC bus will I get any issues with address conflicts with locos or other accessory decoders? The layout is a Freemo module, so I have no control as to how other people have set up their point control or loco addressing Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.