h5djr Posted September 18, 2015 Share Posted September 18, 2015 Can the new Lenz LH01 hand-held controller be used with the Roco Z21 system Link to post Share on other sites More sharing options...
Phil S Posted September 18, 2015 Share Posted September 18, 2015 Does it use Lenz's Expressnet® ??? - If so, and with any appropriate adapter plug, then the answer should be yes. The Z (upper case) 21 (black) supports several protocols. The white z21 fewer... Look at http://www.z21.eu/en/FAQ-Support/FAQ to see the options clearly - pictures of both units, showing the connectors provided. X-bus = Expressnet® (Copyright Lenz) Link to post Share on other sites More sharing options...
ExPatBrit Posted September 18, 2015 Share Posted September 18, 2015 Sorry if this is off topic, but while we're discussing the Z21...... I think the Z21 software shows an awful lot of promise, but there are several things, (as far as I'm aware), that can't be done on a Z21 that can be on it's more accomplished brethren like the ECoS, Intellibox or Central Station and if it could, I'd buy it in a shot. Does anyone know if and when the Z21 will be able to do shuttle trains? I know it can be induced to work with specific makes of decoder, but that has zero interest for me. Any advice greatly appreciated Roland Link to post Share on other sites More sharing options...
ExPatBrit Posted September 18, 2015 Share Posted September 18, 2015 Roland, there's a specific Z21 thread running (but not recently active). Probably best to ask your question there. Thanks for that, will do, if I can find it. I did suspect I was OT. Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.