john77 Posted September 22, 2015 Share Posted September 22, 2015 I hope someone can help me understand a problem am struggling with. I've looked at the wiring diagram on page 6 of the manual for this part,Figure 1: Direct Home Wiring Example I can see where the two wires from the Direct Home Booster, Rail B detection common and Rail A Zone common go but I cant see or understand where the two wires of the dcc bus wires that power the track work fit into this set up go I understand the reason for insulating the track for block detection to work. Am just confused by it all now, I have done a lot of research around DCC automation and intend to run and control using railroad & co traincontroller I'm not the kind of person to jump in with both feet and like to understand exactly what am doing. Any help on this subject would be more than welcome. Many thanks John. Link to post Share on other sites More sharing options...
Adrian Wintle Posted September 22, 2015 Share Posted September 22, 2015 Since Rail A and Rail B come off the booster, these should be the DCC bus wires (i.e. one side of the bus goes via the BDL168). Adrian Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.