Jump to content
 

Four Feet Lane Mk2


Recommended Posts

Several years ago I made a small depot layout called 'Four Feet Lane', see my signature below for the link.

 

Late 2014 I decided to re-build a similar layout after having withdrawal symptoms!

Using a scrap piece of 4x1 plywood I built a small DCC layout, complete with basic scenics.

 

Due to work around the house the layout was side lined until a week ago when I dug it out and had another look at it.

My hasty build had miscalculated the space to allow the miniature crew to leave the loco against the rear back scene so a thin strip of ply was added.

I also rewired the Electrics due to a couple of soldering issues.

There is no fiddle yard as such. locos just run behind the depot building.

 

As I write this I have just finished cleaning the excess grease from my Bachmann class 40 after they were produced! It has

certainly improved it's running. All done with ELO belting out the speakers! Smashing!

post-6856-0-98082500-1451748210_thumb.jpg

post-6856-0-23785200-1451748235_thumb.jpg

post-6856-0-23574300-1451748254_thumb.jpg

Link to post
Share on other sites

A while a go I bought a low relief Resin factory from SkyTrex I think. I had an enjoyable time painting it.

post-6856-0-90532700-1451851928_thumb.jpg

 

So... having a spare couple of hours this afternoon before going out I made another low relief factory.

Some foam board was measured and cut.

post-6856-0-86693600-1451852034_thumb.jpg

 

Plasticard brick was glued to the lower half with PVA

post-6856-0-24128700-1451852094_thumb.jpg

 

The top half was fitted with some corrugated plasticard.

post-6856-0-41849900-1451852170_thumb.jpg

 

I fitted some roof sections and some end boarding. Finally a spray with some grey primer then wiping off the excess from the brick. A little too much grey so I will correct it later in the week.

I am pleased with how it turned out. Just some drain pipes to add and maybe signage.

Paul

post-6856-0-45100800-1451852521_thumb.jpg

Link to post
Share on other sites

  • 2 weeks later...

I had a go at adjusting the colour on the factory side by using some coloured pencils.

Never done this method before and I thought I would try it after seeing it on a BRM video a few issues back.

 

I sill have the drainpipes etc to add.

post-6856-0-10531100-1452549127_thumb.jpg

 

Also new is a laser cut terraced house rear low relief kit from ebay produced by 'In the Green Wood'

The sides are a little on the thick side but painting it is very therapeutic!

post-6856-0-63575200-1452549154_thumb.jpg

 

Finally more ebay purchases. This time some yard lights.

post-6856-0-57968700-1452549181_thumb.jpg

 

Thanks for Looking.

Paul

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...