Bino Posted May 22, 2016 Share Posted May 22, 2016 Hi Folks, back again with another question. I'm using (or will be soon) a stud & probe system for point motor control. The Peco studs come in a pack with tag washers. Can anyone tell me how the Tag Washers should be used? cheers, Dave Link to post Share on other sites More sharing options...
cliff park Posted May 22, 2016 Share Posted May 22, 2016 Bolt through board, immediately underneath board is tag washer, then nut. Solder wire to tag washer. Edited to say, sorry, bifurcated rivets, didn't realise. So, rivet through board, tag washer, open up rivets to lock in, solder wire to tag. Link to post Share on other sites More sharing options...
Bino Posted May 22, 2016 Author Share Posted May 22, 2016 Thank you. It all makes sense now. I was wondering why the pin was split. Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.