dougattrenholmebar Posted February 14, 2018 Share Posted February 14, 2018 Before anybody jumps down my throat, I know that there has been discussion in the past (more than three years ago) about resetting the ZTC214 decoders (I have read them), I was wondering if anybody has had any luck resetting them to factory settings using the ECoS. I have some loco's with these installed and would prefer not to take them to bits to install new ones. Link to post Share on other sites More sharing options...
JJGraphics Posted February 16, 2018 Share Posted February 16, 2018 Before anybody jumps down my throat, I know that there has been discussion in the past (more than three years ago) about resetting the ZTC214 decoders (I have read them), I was wondering if anybody has had any luck resetting them to factory settings using the ECoS. I have some loco's with these installed and would prefer not to take them to bits to install new ones. You'd probably do much better for answers if you posted this in the DCC section. If you ask nicely Andy might move it for you . . . Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now