RSS Fetcher Posted December 22, 2018 Share Posted December 22, 2018 Hi Everyone, I wonder if someone can help. Back in March 2015 I brought a C Class 0-6-0 from Bachmann - really nice. It has not had much use, and, recently, I put it on a train, turned on the controller (analogue) - no movement. I removed the loco & tender body, and checked to see if all the wires were/are in place. All looked good. Put train back on the track - less body - and the engine went well. Job done? Not quite, on putting back the loco & tender body the loco, again, would not work. It is obvious that the motor is OK but, for some reason, perhaps, the DCC part of the loco is at fault. I have no interest in fitting DCC to my layout, so, is it possible to remove the DCC fittings/wiring? I would appreciate your comments. View the full article Link to post Share on other sites More sharing options...
Recommended Posts