Traintronics Signals with Feathers

[PaulK]

Hi All,

I tried this in "infrastructure, p/way and signalling and didn't have much luck, so I thought I'd try it here.

I was wondering if someone could help me. I have a 3 aspect Traintronics signal with Junction Route Indicator (Feathers). I'm using the DCC Concepts Omega point motor, and, as far as I can see, I've wired the signal according to both set of instructions. The 3 aspects of the signal work fine as does the point motor, but what I can't get to work is the feathers if the points are reversed.

 

Any Ideas?

 

Thanks in advance for your help.

 

Cheers.

Paul

[Junctionmad]

Reading the manuals , it’s seems you need to run 12v through a spare contact on the cobalt , wire the 12v to the common position on the cobalt , either the associated normally open contact or normally closed contact is then connected to the 12v “ feather “ on the traintronics board . You may need to change from either the NO or NC depending on whether the feather lights up for the diverging route or not. 

 

Dave 

[PaulK]

Hi Dave,

Yep, that's what I thought and have wired it as you suggested, but unfortunately, no joy!

 

Cheers.

Paul

[Junctionmad]

Suggest you draw out what you wired and post here