anstyman Posted November 22, 2019 Share Posted November 22, 2019 Got myself a class 90 fitted with a loksound v5 sound chip. I need to lower the maximum height of the pantagraph so it doesnt hit any bridges but i am struggling with the CV values. When i stick her on the programming track i cant seem to adjust the pantagraph max height cv value, and sometimes i get error 01 on the lenz indicating a short circuit. I have heard a rumour that i need to remove the chip from the loco to program which would be a pain ?? Any help much appreciated ! Link to post Share on other sites More sharing options...
Pete the Elaner Posted November 22, 2019 Share Posted November 22, 2019 You need to set a couple of more CVs to effectively unlock the pantograph settings. CV 31 to 16 & CV 32 to 0. CV368 is the one you are looking for. I think both of mine are now set to 45. I found something strange when setting them. I started with 1 & got the height right with that, then copied the CVs to the 2nd model. You would hope that the pan would raise to the same height, but this was not the case. After adjusting CV368 a couple of times, the pan now raises to the same height as loco #1 with the same settings I gave it when I copied them across. It didn't make much sense to me first time either, but it is all in the manual & makes perfect sense now. Link to post Share on other sites More sharing options...
Pete the Elaner Posted November 22, 2019 Share Posted November 22, 2019 & I programmed them while in the loco. Link to post Share on other sites More sharing options...
anstyman Posted November 22, 2019 Author Share Posted November 22, 2019 (edited) Thanks for the advice I have already tried adjusting CV 31 and CV 32 but all I get is error 01 on the Lenz controller The loco works perfectly including all the functions when on the layout. Edited November 22, 2019 by anstyman Link to post Share on other sites More sharing options...
LNERandBR Posted December 11, 2019 Share Posted December 11, 2019 Are you able to program any other cv's on the loco or do all of them give you the error 01 message? Link to post Share on other sites More sharing options...
Pete the Elaner Posted December 11, 2019 Share Posted December 11, 2019 On 22/11/2019 at 20:00, anstyman said: Thanks for the advice I have already tried adjusting CV 31 and CV 32 but all I get is error 01 on the Lenz controller The loco works perfectly including all the functions when on the layout. Sounds like you are doing this on a program track (read/write mode) & the system is failing to read back the values? You should not need to read back any values so have you tried doing this on the main (write only)? Link to post Share on other sites More sharing options...
anstyman Posted December 17, 2019 Author Share Posted December 17, 2019 Yes I have tried it on both the prog track and on the main and I get the same errors using both methods Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now