Current usage by servos

[ITG]

I use Heathcote servos to drive uncoupling ramps for tension lock couplings, via a separate 12v DC supply. As I’m now on the verge of building a new layout, I’ve realised that I didn’t pay a lot of attention to power usage for the wiring I used previously. It was 6 way cable - maybe alarm cabling. It worked without problem so presumably ok. The multi colours help with wiring back to push buttons, and using a common negative.
I’ve seen 10 way ribbon cable, sized 28AWG 7.0, for the new layout. Is this likely to be ok for these servos.

thanks

ian

[Crosland]

If you are just referring to the wiring to the buttons then it should be fine. I don't know the design, but there should be no appreciable current through them.