Locksound Micro problem

[tomp]

I have a new blank Locksound Micro v4, it's a six pin and came with the usual pre blown diesel sound.

 

I also have a Locksound programmer and decoder tester.

 

I wanted to use this decoder as a sort of plaything to assemble sound files.

 

So my problem is after re blowing with a downloaded Locksound steam project it seems to be screwed up, the sound seems to be running too fast and there is no motor control also it won't read the cv's, on the decoder tester the leds for the lights are permanently on, when I wrote the sound project I did make the stupid mistake of not using a v4 micro sound project but thought by reloading the correct one that this would rectify the problem.

 

Is there anyway the decoder can be rectified?

 

Thanks

Tom

[tomp]

Problem sorted, just in case anyone else has a similar problem...it was bad contacts