michaelp Posted September 15, 2014 Share Posted September 15, 2014 During the fitting of one of the PL 10E point motors I managed to cut the operating pin too short by mistake, is there a way to fix this or is the motor now useless? Thanks in advance. Michael Link to comment Share on other sites More sharing options...
BlackRat Posted September 15, 2014 Share Posted September 15, 2014 Depends how short, the PL10 used to come with an extension pin and a piece of small brass tubing to fit between the two? Give that a go, that's what the extension pin is for....... Or if you don't have one, try a piece of brass tubing and a suitably size piece of wore or pin, super glue or solder them together.......works fine.... I know! :-) Link to comment Share on other sites More sharing options...
michaelp Posted September 15, 2014 Author Share Posted September 15, 2014 it's probably only a few millimetres too short, when I got the motor it was already fitted with the extended pin (PL 10E) Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.