Simons Posted February 7, 2010 Share Posted February 7, 2010 I have a Dynamis Control and bought a Accessory Decoder, these I have connected to Peco PL11 Turnout motors. The motors do not push the turnout fully over, Do I need to put a Capacitor Unit in ? and if so ware do I put it? or reconfiger the controller. Be pleased for any help Simon Link to post Share on other sites More sharing options...
Guest 838rapid Posted February 7, 2010 Share Posted February 7, 2010 I had simular troubles,however i found that it was friction on the point blade fixings. It was where the tie bar passes over the track. My solution was found using some dry graphite powder sprinkled on the slide surfaces. Also worked for a friends layout that was playing up. Might be worth a try I dont understand why it has put lines through all that?? Still here goes. I had simular troubles,however i found that it was the friction on the point blade fixings. It was where the tie bar passes over the track. My solution was using some dry graphite powder sprinkled on the slide surfaces. Also worked for a friends layout that was playing up. Might be worth a try Link to post Share on other sites More sharing options...
Simons Posted February 7, 2010 Author Share Posted February 7, 2010 Thank you so much, shall give it a go and let you know how i got on,be about 10 day befor I get time again. Thanks again. Simon Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.