Here's a couple of methods you can use for making replacement coupling rods.
Its not unusual when scratchbuilding a new loco chassis to make the rods first and use them as a jig to drill axle bearings holes or holes for axle bushes, but there are times when there's a need to make replacement rods. Here are a couple of methods that may be of use. The first method is the simplest, but requires the use of either a milling machine or compound slide mounted on a bench drill. For those that don't know what a compound slide is, a simple miniature version can be found on the GW rivet press, one slide moves the workpiece in the left /right axis, and the second slide moves in the forward / back axis, the workpiece is moved by turning calibrated dial knobs on each slide. Compound slide tables can be added to any bench drill, you could even use a single axis slide from a lathe and bolt it to the drill table. This enables you to move the workpiece a precise distance, so that one crankpin hole can be drilled, workpiece is moved a determined distance, second hole is drilled.
Second method requires the use of a lathe to modify a couple of axles that are turned down at each end to the same diameter as the crankpin bushes.
A third method not illustrated below is to use the loco's chassis as a drill jig.
Clamping the chassis to some rod material and spot drill through the bearings to leave a tiny indent as a drilling guide. Problem with this method is that some bearing material will probably be removed unless an 1/8" dia shaft was used with a smaller drill force fit in the end of the shaft.
Snitzl.
Edited by snitzl
Re-Upload Images.
0 Comments
Recommended Comments
There are no comments to display.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now