Stucktwit

Hi, I have the Dynamis Ultima and cobalt motors, set all the motors/addresses and all works fine especially the one IP motor I purchased for test, I think it's brilliant. The minor part is I can't remove the self centre on start up from the 8 points connected to the ADFX8 which means I need to go through each point number and press direction every time to move from centre to direction. It appears that you can't enter 198 to remove centre position as you can only go to 100 on the Dynamis is this correct? I have accessed cv settings on the controller,198 and entered 1 but reading above this is not correct ...any ideas please