Thank you all for your advice and guidance which is much appreciated. The layout is now fully wired and all areas can be reached
The layout plan from harlequin was particularly helpful and I hope note to trouble you again for another 6 years
Regards
Fordend
The other layouts worked okay however I still have problems with this question for my new layout. Despite reading Brian Lamberts notes and advice from members I am unable to grasp the electrics side of the hobby so excuse me for being a bit thick
Doug Bailey
The attached plan shows my new layout with the power connection
When either of the two points are operated to allow access to the sidings their appears to be a short circuit
All points are electrofrog
Would it be possible to advise me what would be required to allow these to operate
Thanking you in anticipation
Doug Bailey
Thank you all for your comments, what I was really after was someone to indicate on my plan what was needed
by way of where the power should be connected and where the gaps should be.
If any none is prepared to do this I would be very grateful
Regards
Fordend
I have attached a layout plan, all points are electrofrog and there are no gaps. When I open the point for the siding the locomotive stops, can you help with what I need to do to rectify this
Regards
Doug Bailey
I have attached a layout plan and would like advice on how to provide power to the two sidings circled on the plan.
All points are 009 Peco Electrofrog and I only have one controller which supplies power as shown
Any help would be appreciated
Regards
Fordend
I have attached a copy of my current layout and have a problem with the siding indicated .How do I get power to this area
and where do isolated fishplates go. I have indicated where the power feed is. Any help would be appreciated
Doug
Thank you for your help. I have only one controller but am unclear as to how you would wire this to the three sections you mention. Can you clarify how this is done
Regards
Doug
I am having trouble wiring my new layout. I have attached a plan which shows where the current feed is but cannot work out how to
supply power to the track marked with a circle.
All points are electro frog. Any advice would be appreciated
regards
Doug