Hello fellow members, i'm new to the site so bear with me for the long explanation of my problem, I am using the lenz system on my layout using the 100 set version 3.6, I have just won a li-usb to use my iaptop to control my system this is the early model and it came without the usb cable so I thought the printer cable which looked the same as the original. After reading the instructions I first plugged the device into the lenz system to see if the expressnet light would light up as it should, this was as it should next plug the usb cable into the module and the laptop to find it would not connect so I suppose I will have to buy the right cable from lenz. My problem is after connecting the device to my layout on one of the tracks the abc programme seems to have gone haywire ,when I run my loco around when it drives into the first section it slows down to a virtual stop then speed up in the breaking section and does not stop in the breaking section ,I've reset the system to factory settings but still the same thing happens on the one track, the other engines without a chip set with abc run through without stopping this system is new to me so I would appreciate any help on this problem. Thanxs for any help,
Art54