Applesandpears

Wow ! Thank you so much Phil for your detailed response and time to explain all that. The clips where put in by myself as a trying process when I was playing around. Sooo with regards to the best place to connect the bus wires would you have any suggestions, I can isolate the points as you suggested and remove the clips if required - thanks Phil I know I am asking a lot

Thanks for your replies so far With regards to the points I genuinely don't know which ones they are ! I inherited the layout and the layout is pretty much complete. I have attached a picture of one of the points (they are all the same) can anyone tell from the picture if it is live or insulated ? I guess once I know this will help with the wiring solution

Hi all New to the forum so hello I'm looking to wire up my old layout for dcc I have a Bachmann ez controller to start with and want to run bus wiring around the layout my question is where ? I currently have power clips on my points but I'm guessing with the right wiring I can get rid of these. I have attached a crude drawing of the layout to support its approx 8ft long each section and about 2 ft wide I'm planning on soldering the wire and attaching with droppers Any help would be much appreciated as I'm not sure the of the best approach Thanks