psychosonicsid

All sorted, thanks to all for input. Oh and don’t ask what I did, ‘cos I have no idea:-) I think the problem was me over complicating issues. I had the wiring and motors wired correctly, just the layout diagram on the ECoS wrong. I was coming into turnouts set against the flow, hence the shorts. I find it difficult to visualise the route though the double slip:-( Anyway, once again, thanks all for comments.

Yes tried that and thought I had it until I found another short taking one of the multiple routes through the config. :-(

Hi, Yes, I know but Peco don’t do a single slip in ‘O’ and not really up to the challenge of making on myself. So double slip it is. Thanks for response.

I think so too, will go and play again, just gets so frustrating:-(

iPdigital switches installed as per DCC Concept instructions, (I think :-). Thanks anyway.

Thanks for this. I have completely isolated the double slip to no avail. I am going to have another play with the multimeter in a while. Agreed re single slip, but do you think this double slip / turnout configuration will actually work on DCC?

They are, beat me to the answer. :-)

Yes thanks - have tried exactly that but doesn’t seem to work with the addition of the turnout into the double slip. No idea why.

Hi all, I am hoping you can end my nightmare as I am really struggling with a DCC configuration using O scale Peco double slip, a medium right hand turnout and ECoS Controller. The track layout is a simple double loop with an Up Line and Down line with a small station and good dock coming off and going back on to and from both lines. (See the photo.) I had a huge problem adding the double switch to ECoS so I reverted to 2 x single turnouts. All 8 tracks on double slip are isolated and the motors power the opposite frog polarity as per destructions. All turnouts are registered on ECoS and operate the iPdigital motors as they should but I still can’t get the polarity correct for the cross over or changing lines. (Straight through works fine.) Anyone offer simple advise on how to wire this would be gratefully received. Many thanks