Hi TTG
I have the same issue that prompted this thread, but have tried the solutions without success:
1. ESU ECoS 50200
2. LDT signal decoder for British signals
3. I only have the J3 jumper on for programming
4. One signal wired up to the right hand block
5. Press the programme button twice, and the three aspect signal alternates red and green slowly
6. Use a dummy point to set Normal or Reverse to program the signal
7. No change to the signal flashing red and green at the same speed as before - no speeding up as suggested in the manual
8. Press the program button once more and the signal returns to a steady red aspect
9. The signal does not respond to programming either address 1 or address 305 (my preferred address, and I think correct as the start of a block of 8)
If you have any ideas or suggestions to put me right, I'd be grateful
Thanks
David