" If you configure each of your points to constantly pass power all the time (this is done by altering one of the small screws on the bottom of each point) then the two wires from your dcc system should power every part of the track all of the time. "
Thank you as not all my points are not isolated, this was my next question.
:-
If I connect my z21 to the bottom track, with blue going to the top rail. And points 1 are NOT isolated, so straight 1 or 2 have power. Then points 2 ARE isolated. So everything is dead from this point. As I have been told NOT to directly connect my red and black wires out of my points to the bus wire, I cannot check, at this moment in time, to see IF the track is also fed power, or if it is just the point motor ?