Hi
I have used Scarm to map out a proposed layout - OMG Scarm is addictive
I will be using Peco 75 flexi for track, crossovers and points.
The track will be DC only and the trains will be steam only, no set period just what I have seen on NYMR,
The layout is not based on anything apart from my limited imagination.
The sidings are there to park the loco's, 10 in all and some carriages and rolling stock.
The curves at the end are based on Rad 4 outer and Rad 3 inner albeit I have used the Hornby radius when planning this and substituted with flex, I needed to get the correct bend. Using Hornby radius appears to squeeze me into the 12ft by 4ft board.
I will be using a Gaugemaster D twin controller for the layout and obviously just running 2 trains at a time, the base board will be 4mm hardwood plywood supported by an underframe.
The points likely to be electrofrog will be manually changed initially until I get electrified.
Layout possible.pdf
Questions
Will it work !
If I park a train in a siding and swap the point to another train in another siding (both on the same circuit) will that train move.
Assuming all points set for one train only, will all other trains be effectively isolated on that circuit?
Can you see any potential pitfalls arising, short circuits etc or indeed advice on improving this.
Thanks in advance
Chilly