As you can see, it's all a little tight in there! The shiny bits on the cross-member are the lugs that the torque reaction arms will fit into, engaging into similar holes on the edge of the motor housing. The motors project a little bit above this, but not much.
The other bogie, which is yet to have these mounts fitted:
Someone asked a while ago about how visible the gears would be - here's a pic with the motor in roughly the final position (pretend that the file and cocktail stick aren't there )
I don't think they'll be too intrusive once painted black.
Next job is to solder the torque reaction arm mounts to the one bogie, then sort out the kingpin and secondary suspension mounting. The secondary springs need to be soldered in place before the bogies are assembled, as I'm not sure what effect that heat will have on the resin sideframes. Between the springs and the bearing plates, yet to be attached, there will be a screwed adjustment, so ride height can be adjusted to ensure the loco is level. The primary suspension, theoretically, doesn't need this as it is equalised. Both bogies are sitting level, with all 6 wheels on the marble, so I'm confident that all is square and should run OK.
More progress later in the week, with any luck.
- Read more...
- 2 comments
- 558 views