The chassis is well thought out with tabs and slots on sensible place's first stop was to cut of the S7 spacers and compensated frames ( i am F7 modeling and not compensated)
These were therefore scrap so i had practice on soldering the frames together no problems so I cut out and cleaned up the correct bits
and assembled as per instructions. I found I had to ream out the bearing holes a fair bit to ensure a nice fit. The ashpan sides baffled me for a bit until i realised there were 2 etched lines one on each side . a hold and fold was very useful for bending these and the spacers.
next stage fitting the Ash Pan lever ............ er what does it look like I have asked Peter for a list of numbed parts so thats it till it arrives.
I could not resist putting the driving wheels on and it will just need a little fettling as the axles were a tad tight in the bearings
- Read more...
- 1 comment
- 565 views