Peppercorn Posted September 4, 2015 Share Posted September 4, 2015 Good afternoon, all, I was going to make a start this afternoon on the long-put-off task of point building using C & L components. I've been collecting the components for ages. One thing I had, but seem to have lost, are the 'how to' instructions that one could download from C & L website (I did, but not on this computer) and whilst the majority of manufacture is straightforward, if not obvious, there were a few subtleties that I've forgotten. C & L no longer do the downloads so I was wondering if anyone has them that they could email to me, please? Thanks in advance, Cliff Sorry - found it on C & L Link to post Share on other sites More sharing options...
hayfield Posted September 4, 2015 Share Posted September 4, 2015 Cliff Is this what you require http://www.finescale.org.uk/pdfs/ds005.pdf You have the knowledge centre, Exactoscale are in the Home page under 4 & 7 mm respectively The C&L is in the Knowledge centre but in the data sheets section Link to post Share on other sites More sharing options...
Peppercorn Posted September 7, 2015 Author Share Posted September 7, 2015 Thanks, Hayfield, yes it is, I've only just seen your reply, otherwise I would have responded earlier. Cliff P.S. Looked at the instruction, downloaded and working to it! Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.