Digikeijs DR4024 & DR60030 Servos

[dj_crisp]

Hi

 

I'm just struggling with my regular lack of DCC understanding and have found the instructions hard to follow for the DR4024 with DR60030 Servos. So far I've managed to achieve changing the address and have also attempted to change the postions of the servos. The manual states position A, B, C & D but to be honest I don't understand what they all mean (guess A & B are the limits?).  I think I've managed to change them but can only get limited amount of movement out (enough for it to be a signal)  and was hoping to be able to get 180 degrees of movement out of a servo (which I think is the limit?)

 

On a seperate note I see that you can program signal bounce in - Is it possible to have no bounce at one limit then bounce at the other (so try and replicate the sharper return to danger movement?)

 

Thanks for your help

Will

[dj_crisp]

Hi

 

I think the limit with the DR4024 is 90 degrees - Is this true?

 

If so is there a DCC decoder out there that can do 180 degrees? (I'm not sure I can come up with a gear ratio to match 180 with the 90 i have available?)

 

Thanks

Will