Lenz LH100 and Gaugemaster PM10D

[athegn]

I have temporary setup the PM10D and responding to its default address, 1.

 

However I want to change that to 21. I know how to set the PM10D to learn mode but cannot get the LH100 to change the address.

 

I set the PM10D to "Set" and on the LH100 press F5  then press 21 then press Enter. I then change the PM10D to "Run".

 

When I F5 the Lenz with 21 it does not respond; still responds to 1.

 

Any advice please.

 

 

[franciswilliamwebb]

1 hour ago, athegn said:

Any advice please.

 

I've never used a PM10D, but often setting up similar devices requires you to:

 

• Press F5  then press 21 then press Enter (as you say)
• Then press either + or -

 

If you're missing the +/- step might that be the problem?

Edited February 29 by franciswilliamwebb
edited for spelling

[athegn]

Thank you.

 

Yes resolved.