DerickE Posted January 26, 2011 Share Posted January 26, 2011 Hi, I want ti fit point motors to my Peco N Gauge universal code 80 turn outs, can I use OO gauge Peco motors. If so what is the best method to do this, thankyou Link to post Share on other sites More sharing options...
RMweb Premium PaulCheffus Posted January 26, 2011 RMweb Premium Share Posted January 26, 2011 Hi, I want ti fit point motors to my Peco N Gauge universal code 80 turn outs, can I use OO gauge Peco motors. If so what is the best method to do this, thankyou Hi Yes you can if you mean the PL10 type. I'm not sure about the PL11s. I mounted mine under the baseboard using the Peco PL9 mounting plate and a slot through the board the motors were the PL10-E (extended pin). Cheers Paul Link to post Share on other sites More sharing options...
RMweb Gold Revolution Mike Posted January 26, 2011 RMweb Gold Share Posted January 26, 2011 Yes - the peco motors are not OO gauge specific (assuming you mean the under the base board motors). The easiest way is to cut a rectangle in the baseboard for the motor and use the metal lugs on the motor to fit into the peco points. Alternatively cut a much smaller hole for the point rod and use washers and screws to attach the motor to the underside of the board. IIRC there are instructions how to do all this with the motors. Cheers, Mike Link to post Share on other sites More sharing options...
DerickE Posted January 26, 2011 Author Share Posted January 26, 2011 Thanks for your replies Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.