Steve Williams Posted April 17, 2012 Share Posted April 17, 2012 Sorry should have been more specific. It's the hand one not rotary (i should try the rotary) and yes 40thou is 1mm. Hope this helps. mark Thanks Mark. I thought I had done the sums correctly Link to post Share on other sites More sharing options...
SquireBev Posted April 18, 2012 Author Share Posted April 18, 2012 Well I've persevered with my modelling knives and managed to cut out all my windows and doors on the mill buildings. Link to post Share on other sites More sharing options...
Guest Celticwardog Posted July 26, 2013 Share Posted July 26, 2013 I find that even with 40 you shouldnt need to actually cut all the way through. usually a deep score is enough then bend and snap. You have to bend it quite a bit to get windows out but the stuff is very forgiving as bouncing back so it does work. Link to post Share on other sites More sharing options...
allan downes Posted July 27, 2013 Share Posted July 27, 2013 Once I cut the end glazing frames for a good shed in one complete fret out of 80 thou styrene - never again ! Below, the shed ! Link to post Share on other sites More sharing options...
grahame Posted July 27, 2013 Share Posted July 27, 2013 I find that even with 40 you shouldnt need to actually cut all the way through. usually a deep score is enough then bend and snap. I've found that not cutting through plasticard, but effectively scoring, bending and snapping, can sometimes leave a ragged tear and damage on the non-cut side - so I don't recommend that now and prefer to cut completely through for a nice clean cut edge on both sides. G. Link to post Share on other sites More sharing options...
Guest Celticwardog Posted July 27, 2013 Share Posted July 27, 2013 I've found that not cutting through plasticard, but effectively scoring, bending and snapping, can sometimes leave a ragged tear and damage on the non-cut side - so I don't recommend that now and prefer to cut completely through for a nice clean cut edge on both sides. G. Oh thats odd, never had that happened and used several brands. Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.