HeeleyBridge Posted April 6, 2015 Share Posted April 6, 2015 I was more than happy with my 1F, which I bought last August but having no layout only just got around to fettling, until I took off the body to fit three link couplings. I sent the chassis of around the running in loop and noticed that the centre driver is not square on the axle. I have tried the obvious prising with a screwdriver (as carefully as my arthritic hands will allow), but to no avail so far. The BTB must change by over 1mm with rotation. Any ideas? Dave Link to post Share on other sites More sharing options...
Silver Sidelines Posted April 7, 2015 Share Posted April 7, 2015 hello Dave, I thought you might have had a reply by now. A telephone call to Barwell? Regards Ray Link to post Share on other sites More sharing options...
HeeleyBridge Posted April 7, 2015 Author Share Posted April 7, 2015 Thanks Ray, I think it might be the best option, I was just hoping to avoid it. I'll see if a replacement wheel set is available. Dave Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.