Goolwa1854

Hi all, I am replying to the question of supplying power to the bridge. I have included a picture of a miniature slip ring that I am using. These can be 2 to 12 wires, which should be enough to do what you want to do. Most electronic stores should have, or, can get them, just Google. Barry.

OK, thanks for that. I was having problems with the sketch for one DCC address, but the multiple DCC address's sketch has worked. Not sure why the single address sketch did not work, will print out both files and compare. Thanks again, Barry

Hi, just a quick question. Is the Adafruit Digital I/O 2 pin enabled?, as I could not see it mentioned in the sketch in Post #17, only the I/O 3 pin. Barry

Hi to everybody, I was recently pointed to this forum by another member. I have been playing around with the Arduino & stepper motors for a while now, and recently purchased a Walthers 90' TT, non motorized, with the intention of DCC control via Arduino & stepper motor; so this thread has been very, very helpful. I am using the large gear supplied with the TT, as I am using a miniature 12 wire slip ring to supply power/control to the bridge. The main reason I am posting, is that I have a Digitrax system, and would like to use that as the connection to the "DCC - Arduino Turntable Interface" diagram from post #8. I would be very grateful if someone could tell/show me what needs to be changed to allow connection to the Loconet bus. Thanks in advance, Barry from Goolwa South Australia