Jump to content
 

Welsh Signaller

Members
 View Profile  See their activity

  • Posts

    284

  • Joined

  • Last visited

 Content Type 

Everything posted by Welsh Signaller

  1. Welsh Signaller
    Bridge over the River Wye Step by Step Pictorial: (1) Drill out the handrail holes in the supports. (2) Trim excess from the bottom of the supports. (3) Attach, and secure the uprights into the side plates. (4) Run some spare wire through the supports to open up the holes.
  2. Welsh Signaller
    “Bridge over the River Wye” update: Handrail supports secured into the side plate, primed and ready to paint at some point. I’m going to construct a brass central support which will sit in the river which will have one of the remaining spans sat on top.
  3. Welsh Signaller
    Work continues on the “Bridge over the River Wye” Drilling of holes in the bridge side plates to allow supports for the handrails to attach to.
  4. Welsh Signaller
    Bridge side plates primed, and the raw corner ready to go.
  5. Welsh Signaller
    Concept drawing of how I plan the dismantled Waterloo Branch river crossing to be. The bridge in a state of demolish, with one side complete with deck and the other hair side plates remaining - with the tunnel beyond.
  6. Welsh Signaller
    Deleted
  7. Welsh Signaller
    Deleted
  8. Welsh Signaller
    Deleted
  9. Welsh Signaller
    Ragstone Models white metal Great Western Buffer Stop. Stage eight, buffer stop assembly was left to dry overnight - I’ve given it a coat of primer, again leave to dry.
  10. Welsh Signaller
    Ragstone metal Great Western buffer stop assembly, I’ve two to build for the siding and headhunt. Ive also got a ground based water crane to build.
  11. Welsh Signaller
    Deleted
  12. Welsh Signaller
    Deleted
  13. Welsh Signaller
    A few little snaps for fun.
  14. Welsh Signaller
    Deleted
  15. Welsh Signaller
    Deleted
  16. Welsh Signaller
    Deleted
  17. Welsh Signaller
    £47.50 is a snip for a fully operational O gauge signal, the ball being 30% to small isn’t going to bother 98% of people.
  18. Welsh Signaller
    Deleted
  19. Welsh Signaller
    Deleted
  20. Welsh Signaller
    With DCC bus and droppers installed, I’ve made progress on laying the actual track. Point motors will be fitted later, holes have been cut in the track bed under the points ready.
  21. Welsh Signaller
    The DCC bus power wires have been secured to the underside of the raised trackbed, I’ve also attached the droppers to the track that I’ve laid so far. However im unable to test it at the moment as i don’t have a controller yet!
  22. Welsh Signaller
    As this is the storage area I’ve decided to fit the bus line on top of the traverser to the side of the three storage lines, with male/female connectors either side.
  23. Welsh Signaller
    Deleted
  24. Welsh Signaller
    Deleted
  25. Welsh Signaller
    Deleted
×
×
  • Create New...