Hi does anybody have a photo of 31283 in large numbers livery I need a photo which shows the number nearest to the drivers side to see if it has a kingfisher on that side, I have found plenty of photos showing the other side. Thanks Alan
Hi I have been building the DJH 02 kit myself, however I have misplaced the screws that hold the coupling rods on, I have emailed DJH without success, can you remember what size they are so I can source some replacements. Thanks
I am currently building a DJH 02 shunter kit, I have been building it for a few years. I seem to have lost the screws that hold the coupling rods onto the wheels. I have tried to contact DJH with no success, does anybody know what size screws I need as it doesn't tell you in the instructions. Thanks in advance.
Hi looking at converting a Vitrains 37/4 to a 37/5 variant with the flush front, does anybody know if a conversion kit is available or replacement nose, or if anybody has a 37/7 37/5 nose or bodyshell to sell or exchange. Thanks
Alan
Its been a while but got some updates I have built a few more low relief buildings and replaced the loco shed with something that looks less like a box of beer. Next job will be to take off all the track and buildings paint the back scene, when that is done I can sort the points out going to use the wire in tube method for that.
Believe they were all the same size, when plaques and plates are printed on locos they are usually bigger than the replacement photo etched part, in my experience anyway.
Believe they were all the same size, when plaques and plates are printed on locos they are usually bigger than the replacement photo etched part, in my experience anyway.
Does anybody have any surplus to requirements NSE mk2 brake coach transfers, I only need to do 1 coach so don't need a full pack. I will of course pay for any transfers anybody has. Thanks
It's a long shot but does anybody have a spare Bachmann 108 DMU radiator, I purchased one off eBay u fortunately it was missing a radiator from the powercar. Or does anybody have a spare radiator 3D printed or cast from resin that would be suitable. Thanks