CHAZ D

I have done this I used a Zimo Z2 https://www.digitrains.co.uk/z2.html I had to remove the PCB in the trolleyand hard wire from there using shellac to protect the wires from shorting. Chaz

Or Duck tape!

Country Railway Routes Guildford to Redhill https://strathwood.co.uk/products/country-railway-routes-guildford-to-redhill?_pos=1&_psq=redhill&_ss=e&_v=1.0 The Southern Way (search Strathwood) Series many volumes (need searching by title Southern Times (search Strathwood) Some in the first 6 volumes I will check for others Chaz

LOL a

I have similar not good for decoder wire but excelent for beefier bus wire. They will allow you to open up the insulation in the middle of a bus wire run to solder to. Chaz

I filmed this just east of Reading a few years back Very precarious I would think!

When I was 9 my uncle, who was a professor of veterinary medicine brought me an Airfix Wellington bomber which I made very badly (glue everywhere). This started a passion for me as a solitary child (long story boarding school) for building Airfix models. I probably built most of the Aircraft military vehicles and had 1000's of the soldiers available in 65-70 plus a few Revell kits. I found out later that the Wellington had a personal link to my uncle as his brother was a rear gunner in a wellington and he died when it was shot down.

I use a track rubber with the corners cut back to fit inside the track and the edges cut to clear the 3rd rail! points are more difficult so I use 5-7mm strips of the track rubber and use them carefully.

Having worked a a university for 34 years as a lab technician (Microbiology and Virology 16 yrs) then a computer officer for 18 years and building 400+ computers i(ncluding 2 25 computer arrays for DNA sequencing). I regularly came across academics who could not undo a nut but others who could build car motors and one who had restored a traction engine . To me it was down to the interest in a particular thing that gave the impetus to learn and try!

I added after ballasting (easier to lay and level ballast!).

It worked fine today! Ordered a body and seating as I have a spare coach someone gave me. Hope its just a straight swap. I can modify the underframe to match. then I will have to renumber the remaining coaches of the 4CEP set.

I have the image of Triffids when at roadworks I see the sign. "HEAVY PLANT CROSSING"

press escape 4 times to use programming track and hit Enter hit 1 and it will read manufactuer enter chip ID enter do you want to 1 for yes and it will read the short address and allow you to change it (hit 1 to save address and make it the address Enter to not change the address) it will the ask for long address put in address as required and when asked hit 1 to make that the active address Enter to do nothing Escape back to main menu (if you don't want to change any CV'S

There are reviews on "Sams Trains" on YouTube. It seems a total piece of cheap rubbish the valve gear in particular.

Now £10.28 + £5.00 P&P Almost certainly was a mistake