I have the same controllers they wont work with DCC fitted locos they are
designed for varied pulses so locos keep a constant speed, thats the
reason i use them you can get your locos to run as slow as you want,
not measured the voltage out put.
Has any one tried fitting a switch on these so the sound can be switched off
so there is no sound when you handle it saves on batteries too, just want to
know if it is possible before purchasing.
Looking for a replacement for a missing one from Bachmann 10000 diesel
if any one has an original Bachmann spare please pm me, or any suitable
replacements, read on here the Markits 5mm brass ones are over scale can any one
confirm this.
I think this is not the same as the replacement Bachmann sold as the
Replica had a rear driven pancake motor with traction tyres thanks
for the offer though.
Any retailers have any old stock of these or might consider a
second hand one but must have tight fitted wheels on axles
and a quiet motor.
Yes have seen this i would if i had a decent printer but
then again can you get paper as thin as transfers
it would probally cost as much to get these printed
professionally.
Yes i thought so have seen the ones on Wizards but was hoping
they did a mixed selection all on one sheet there available in
7mm but not 4mm unless some one has seen these.
Do they have there own website only seen there products on
traders who list a sheet of assorted wagon posters but
only available in 7mm works out expensive buying all
there seperate sheets if you only need a couple of each one.
They informed me these are only spaced at 2mm as oposed to Wizzards at 4mm if any one have replaced there Bachmann ones not the old
Mainline tooling i would be interested in them.