JPinza55

Yep, though I saw pictures of the samples a few months back so they can’t be too far away.

Like it, though quite surprised at the absence of the Class 25

Thanks for that, having checked out those videos and the comments it does seem to be the same problems, the locos are pulling too many amps. Will look to send back for repair now.

Hi, Three of my AS Deltic's (DCC Sound) have started to suddenly perform very strangely. All three are now running very jerkily, accelerating/decelerating too quickly, sudden increases and decreases of speed, and often running at a speed contrary to the controller input. My other Deltics (and all other locos) are still running ok so I'm not sure if its track issue or the models themselves malfunctioning. In one case the engine was running fine for a while and then started to jerk violently, before running ok and then again jerking. Does this sound like a dirty track/wheels problem, a track connectivity issue or something else?

The plain blue 37 appears to have arrived at Kernow, so can’t be far away from other shops

they did similar with the B1, very much simplified it.

Thank all, after a quick MOT it seems to be running fine- touch wood

Hi, the yep all pick ups look to be touching the wheels (which I believe is correct?). It has also been established that is 100% an issue with loco, as opposed to the track.

It's stalling- sometimes it recovers on its own and goes again, sometimes it completely stops and is only retrievable by pressing the emergency stop button twice.

Hi, my brand new Hornby Black 5 fitted with TTS worked perfectly initially, however after swapping the direction the loco was facing (on the same track), it has started to frequently stall/stop on three out of four curves around my layout. Is this a power issue or is there a potential issue with the loco?

The model just runs poorly. Can you recommend any CV's that could be changed from say default?

My Class 24 is really jerky when running on DCC, but is fine on DC. How can this be resolved? Is this an issue with the pickups?

I'm still having problems with this decoder, the speaker is slipping down when the body is attached and is interfering with the motor, causing poor performance at slow speed and a constant sound. Is there a remedy?

Thanks, it was the speaker pressing down on the drive shaft, seem to be good now. What would the recommended Acceleration, Deceleration and Start Voltage be for the HST on a smallish layout?

No there is no movement whatsoever just a strange recurring noise, although the sound increases/decreases as I turn the toggle