There is a photograph in Jim Russell's book 'GWR Wagons Appendix' that shows a wagon loaded with long, thin conifer tree-trunks, of the kind referred to as 'Norway poles'. For some time I have wanted to model a similar load.

The wagon itself has been described in this blog before, and has a rather chequered history. Amongst other issues, I put washer plates on the inside, corresponding to the attachment points for the sheet supporter mechanism at each end. I was following the RCH drawing for the sheet supporter parts, which was the only information I had at the time; since then, I have seen photos that show the GWR didn't put washer plates on the inside. I therefore wanted to add a load to hide the washer plates I had put in, so this was my opportunity to model the Norway poles.

Making the poles has been a slow process - 15 months in fact. They are made from the twigs of a Christmas tree, with the needles stripped off and most of the bark sanded off. I collected all the suitable twigs from our 2022 tree, but there weren't quite enough, so I had to wait until the 2023 tree became available. Each time, I left the twigs for a couple of months to dry out, then stripped the needles and sanded then with coarse sandpaper. The remaining texture gives a reasonable impression of the partly-stripped bark seen in the prototype photo:

The bottom layer of poles was glued to a piece of stiff card about two-thirds the length of the wagon. More poles were glued on top, and the final layer left loose, as I wanted to ensure there was no glue visible. The roping follows that shown in the photo, and is made with 0.75mm rigging thread, as used by ship modellers - the same technique I have described in previous blog entries. A small amount of thin cyanoacrylate glue holds the knots in place.

And here with a 2-plank wagon as a runner:

Nick.